![]() ![]() By the setting of angle compensation, machine will go from X to M, via N, then arrive Z. See as below Sketch Map: x y a m β n z (Re: how Angle Compensation works) From the above map, the curve will go by X, passes through Y arrives Z. Angle compensation: Because of blade physical structure, the angle cannot cut very sharply thus effect the graph overall appearance, Angle compensation is set for better actual angle cut as sharp as it displays in Graph. ![]() The length unit for Closed Compensates is 1/10 mm, please do not set the value of CLOSE COMPENSATION too large which cause time waste in the cutting process. Note You should set the paper size according to your plotter cutting size as well as media size in order to avoid exceed cutting out of media scope Compensation options: Close compensation: After the machine finish one section of closed curves, it will send commands to blade and continue to revolve this closed curve to 10ġ1 cut a bit of, thus guarantee the curve closed completely. We advice the optimum value should be set between 300mm and 3000mm. It is better to set its value more than 10mm and less than 20000mm. ![]() Please set paper size according plotter cutting size and output medium size. 10 Explanation for each item on this interface: Paper option: Set paper size, you can select the popular paper type from the listed options, or, you can select Custom, and set paper height and width at your request.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |